Skip to main content
B
bblanch
Participating Frequently
October 14, 2025
Solved

Microsoft Graph Failures and HTTP Connector Editing

  • October 14, 2025
  • 2 replies
  • 142 views

I have been trying to set up an MS Graph connector but have had no luck using the knowledge article: Connector | Microsoft Graph. Should I be able to edit a connector once it has been created or is this not an option? Do I need to create a new connector each time I want to test a new configuration for a connector? After saving/testing my connectors many of the variables for authentication are being deleted and I worry this is causing my connector to fail. Is this typical or are these Agent Studio bugs? Additionally, would I need Access tokens (used for implicit flows) enabled for the Moveworks application within the Entra Admin Center?

Best answer by Aaron K

Connectors can be changed, actually all values but the actual name can be modified. Open the connector page, right hand side, there are view and edit buttons. In the page from left to right, Name, Created By, Last Updated, View, Edit, and Delete. If you do not see these functions, ask your MW rep to enable this.

2 replies

A
Aaron KAnswer
New Participant
October 22, 2025

Connectors can be changed, actually all values but the actual name can be modified. Open the connector page, right hand side, there are view and edit buttons. In the page from left to right, Name, Created By, Last Updated, View, Edit, and Delete. If you do not see these functions, ask your MW rep to enable this.

    B
    bblanchAuthor
    Participating Frequently
    October 23, 2025

    Ok that is good to know. I am missing the Edit so I will definitely reach out to them. Thank you!

    Terms & ConditionsAccessibility statement